Front-view camera:

If you are using the camera as a front view display instead, then the display must be revered to make it accurate, as it is shown to fit a reverse camera display. To do so, cut the white wire.

Gridlines:

The parking camera has parking gridlines by default. If you wish to remove these gridlines, cut the green wire.

Installing the mirror:

1. Expand the mirror monitor clamps and place over existing rear view mirror. Adjust the mirror to the best position.
2. Run the cable along and behind the roof lining where possible and connect to camera harness as per wiring diagram above.

Camera installation:

Butterfly mount:

1. Select a flat and centered location near the number plate lamp at the rear of the vehicle to mount the camera.
2. Attach tape to the bracket of the camera and drill a small hole for the first screw.
3. Use a screwdriver to fix the first screw, but don't tighten it yet.
4. Insert camera wire through newly drilled hole and mount securely in place.
5. Mark the position suitable for the second screw and drill a small hole for it.
6. Fix the second screw and tighten both screws.

Flush mount:

1. Unscrew the upper part of the camera anticlockwise, detach the upper part and bracket, and place the bumper adaptor instead.
2. On the bumper, mark the middle position where the camera is going, and drill a hole with the provided 16.5mm hole saw.
3. Ensure the "UP" arrow is positioned upwards, as pictured.
4. Feed the camera lead through the bumper hole before fixing the camera to the bumper.
5. To ensure tight and flat mounting, put the camera into the hole and using both thumbs, press evenly.