Inserting a Micro-SD card:

1. Make sure that the Mirror DVR is turned off and the screen facing is towards you
2. Insert the memory card with the text on the Micro SD card facing you. 
3. Push the memory card in until a click is heard 

Installing the MCPK-502DVR:

1. Loop the rubber fasteners over the top fastener clips.
2. Put the Mirror DVR in position on the front face of your existing rear view mirror ensuring that the camera lens clears the edge of your rear-view mirror.
3. Loop the bottom rubber fasteners over the mirror and attach to the bottom fastener clips.
4. Add optional EVA PADS in-between the rear of the mirror and your original rear view mirror to provide more stability, if fitting is loose 

Connecting to power:

1. Once the Mirror DVR is securely installed onto your vehicles rear view mirror, plug the 12/24V DC charger into your vehicle’s cigarette lighter adapter or power source.
2. Run the cable along your vehicles console and windscreen and plug it into the Mirror DVR port marked with the USB icon

Installing the reverse camera:

1. Select a flat and centred location near the number plate lamp at the rear of the vehicle to mount camera.
2. Attach tape to the bracket of the camera to hold the camera in position while installing, and drill two small holes, one for the first screw, the second to run the reverse camera cable through.
3. Use a screwdriver to fix the first screw, leaving the screw loose enough to adjust the camera.
4. Insert the camera wire through the intended drilled hole checking the installation position.
5. Mark the position suitable for the second screw and drill a small hole for it.
6. Fix the second screw and securely tighten both screws.